Rolma Putty Filler 2K Two-component Spray Sandable Spray 400ml CR6
Allows excellent adhesion on iron, steel, and galvanized surfaces. Quick drying even at high thicknesses.
Quantity:
2K CR6 Filler Putty
Can be overcoated with water-based and solvent-based primers and 1K and 2K finishing paints. If the product is not repainted within 24 hours, it is necessary to sand the surface before repainting.
2K putty with excellent filling power (up to 180 microns), high corrosion protection, and excellent sandability. Allows for excellent adhesion on iron, steel, and galvanized surfaces. Quick
drying even at high thicknesses. Sandable after 3-5 hours at room temperature, after 30 minutes at 60.
DRYING TIMES
Dust-free - 5 minutes
Pot-life - 8 Hours
400ml format
Preparation of the support:
sand as needed. Use degreasing cleaner CR 40.
Instructions for use:
the catalyst integrated into the can must be activated at the time of use, according to the following procedure.
1) Shake the can vigorously.
2) Remove the red cap from the nozzle, and place it on the stem at the base of the can.
3) Position the can upside down on a hard surface and press the red cap firmly with the palm of your hand until it locks; remove the red cap.
4) Shake the can vigorously to mix the components. The can is now ready to be used. Do not spray in cold temperatures and in the presence of humidity.
After use, turn the can upside down and spray for a few seconds. Remove paint with acetone and/or nitro thinner.
sand as needed. Use degreasing cleaner CR 40.
Instructions for use:
the catalyst integrated into the can must be activated at the time of use, according to the following procedure.
1) Shake the can vigorously.
2) Remove the red cap from the nozzle, and place it on the stem at the base of the can.
3) Position the can upside down on a hard surface and press the red cap firmly with the palm of your hand until it locks; remove the red cap.
4) Shake the can vigorously to mix the components. The can is now ready to be used. Do not spray in cold temperatures and in the presence of humidity.
After use, turn the can upside down and spray for a few seconds. Remove paint with acetone and/or nitro thinner.
Disposal:
Aerosol can: FE40 – Iron collection
Cap and nozzle: PP05 – Plastic collection
Recycle only if perfectly clean and empty.
Otherwise, recycle at appropriate ecological centers.
Aerosol can: FE40 – Iron collection
Cap and nozzle: PP05 – Plastic collection
Recycle only if perfectly clean and empty.
Otherwise, recycle at appropriate ecological centers.
