Megasid Aluminum Base Stucco for Aluminum Repairs 250gr + CATALYST
Find main use on aluminum shells and for the reconstruction of missing body parts.
Quantity:
Pickup available at Punto Vendita Monselice Net Coatings
Usually ready in 24 hours
Megasid Aluminum Base Stucco for Aluminum Repairs 250gr + CATALYST
Punto Vendita Monselice Net Coatings
Pickup available, usually ready in 24 hours
Via Emilia 2
35043 Monselice PD
Italy
The two-component putty MEGASID ALUMINUM PASTE is a formulation based on unsaturated polyester resins and aluminum paste; it is an extremely tough and resistant product, while maintaining good characteristics of spreadability and sandability.
It is mainly used on aluminum shells and for the reconstruction of missing body parts. Thanks to its innovative formulation, it is suitable for being drilled and threaded and can also be successfully used to replace some welds.
Instructions for use
Make sure that the surfaces to be filled are perfectly dry and clean; if applying to bare metal, sand it with abrasive paper P 80 and P 150;
Take the amount to use from the jar with clean tools, adding 1 - 3 grams of hardener for every 100 grams of product;
Mix this amount well, combining the two components;
Apply the filler to the surface to be worked on, keeping in mind that the product can be sanded (grit P 80 – P 120 dry) after about 30 - 40 minutes; the curing times may vary depending on the ambient temperature: they shorten with temperatures above 25 °C and lengthen with lower temperatures;
Do not return catalyzed and/or unused filler to the jar to avoid deteriorating the entire contents of the jar;
Close the jar after use to prevent the product from hardening upon contact with air.
APPLICATION: SPATULA
CATALYSIS: 1-3%
DRYING:
GEL TIME: 6-8 minutes
OUT OF PRINT: 10-30 minutes
COMPLETE DRYING: <1 hour
SANDABLE: After 30-40 minutes
Make sure that the surfaces to be filled are perfectly dry and clean; if applying to bare metal, sand it with abrasive paper P 80 and P 150;
Take the amount to use from the jar with clean tools, adding 1 - 3 grams of hardener for every 100 grams of product;
Mix this amount well, combining the two components;
Apply the filler to the surface to be worked on, keeping in mind that the product can be sanded (grit P 80 – P 120 dry) after about 30 - 40 minutes; the curing times may vary depending on the ambient temperature: they shorten with temperatures above 25 °C and lengthen with lower temperatures;
Do not return catalyzed and/or unused filler to the jar to avoid deteriorating the entire contents of the jar;
Close the jar after use to prevent the product from hardening upon contact with air.
APPLICATION: SPATULA
CATALYSIS: 1-3%
DRYING:
GEL TIME: 6-8 minutes
OUT OF PRINT: 10-30 minutes
COMPLETE DRYING: <1 hour
SANDABLE: After 30-40 minutes
Disposal:
Jar: FE40 - Iron Collection
Cap: HDPE2 - Plastic Collection.
Recycle only if perfectly clean and empty.
Otherwise, recycle at appropriate ecological centers.
Jar: FE40 - Iron Collection
Cap: HDPE2 - Plastic Collection.
Recycle only if perfectly clean and empty.
Otherwise, recycle at appropriate ecological centers.
