ROLMA
Rolma Spray Paint Ferromicaceo Micaceous Iron Enamel Direct Adhesion 400ml
Color
Rolma Spray Paint Ferromicaceo Micaceous Iron Enamel Direct Adhesion 400ml
E500 ANTHRACITE
Punto Vendita Net Coatings
Via Emilia 2
35043 Monselice PD
Italy
Mica Iron Paint
Repaintable with itself at any time
Rough Appearance
DRYING TIMES
Dust-free - 15 minutes
Dry to the touch - 30 minutes
Deeply dry - 24 hours
FEATURES
Acrylic anti-corrosive paint. Direct adhesion on metal, wood, and plastic productsThe particular finish, which resembles wrought iron, favors its use in the painting of gates, grilles, frames, drip edges, downspouts, and all those artifacts where a special resistance to corrosion is required. The color E503 combined with black can be used to imitate the Corten effect.
SUPPORT PREPARATION
remove from the surface to be painted any traces of dirt, grease or peeling paint. Sand as needed.
INSTRUCTIONS FOR USE:
shake the canister for about 1 minute.
Apply multiple light and crossed hands while holding the canister in a vertical position at a distance of about 20 cm. Do not spray in cold temperatures and in the presence of humidity. After use, turn the canister upside down and spray for a few seconds. Paint removal with acetone and/or nitro thinner.
Disposal:
Spray can: FE40 – Iron collection
Cap and nozzle: PP05 – Plastic collection
Recycle only if perfectly clean and empty.
Otherwise recycle at designated ecological centers.
Check the regulations of your municipality.
Hazard label:
UFI: 1CXR-5MXG-310J-SUSS
H222 - Highly flammable aerosol. H229 - Pressurized container: may explode if heated. H315 - Causes skin irritation. H319 - Causes serious eye irritation. H336 - May cause drowsiness or dizziness.
P101 - In case of consultation with a doctor, keep the container or label of the product available. P102 - Keep out of reach of children. P210 - Keep away from heat sources, hot surfaces, sparks, open flames, or other ignition sources. Do not smoke. P211 - Do not spray on an open flame or other ignition source. P251 - Do not pierce or burn, even after use. P261 - Avoid breathing aerosol. P271 - Use only outdoors or in a well-ventilated area. P280 - Wear protective gloves, Protect eyes, Protect face. P305+P351+P338 - IN CASE OF CONTACT WITH EYES: rinse thoroughly for several minutes. Remove contact lenses if easy to do. Continue rinsing. P312 - In case of discomfort, contact a POISON CENTER, a doctor. P332+P313 - In case of skin irritation: consult a doctor. P337+P313 - If eye irritation persists, consult a doctor. P405 - Store locked up. P410+P412 - Protect from sunlight. Do not expose to temperatures exceeding 50 °C, 122 °F. P501 - Dispose of product and container in accordance with national regulations.
CONTAINS: Acetone
remove any traces of dirt, grease, or peeling paint from the surface to be painted. Sand as necessary.
Instructions for use:
shake the can for about 1 minute.
Apply several light and crossed coats while holding the can vertically at a distance of about 20 cm. Do not spray in cold temperatures and in the presence of humidity. After use, turn the can upside down and spray for a few seconds. Remove paint with acetone and/or nitro thinner.
Aerosol can: FE40 – Iron collection
Cap and nozzle: PP05 – Plastic collection
Recycle only if perfectly clean and empty.
Otherwise, recycle at appropriate ecological centers.