2K Two-Component Epoxy Enamel 1 KG Glossy Or Matte Available in all RAL

Two-component enamel based on epoxy resins, suitable for finishing products intended for indoor use subjected to heavy operating conditions such as machine tools, workshop equipment, electrical panels, paneling, scientific instruments, and much more.

Highly suitable for indoor use, highly discouraged for outdoor use as it would cause enamel degradation when exposed to UV rays and weather conditions.

After drying, it creates a hard and elastic film with high resistance to water, detergents, lubricating oils, solvents and fuels, acids, and alkalis.

Available in the following finishes: Glossy, Semi-gloss, and Matte

PRICE PER KG each kit contains Catalyst, thinner sold separately CLICK HERE FOR THE THINNER

CHECK THE RAL TABLE IN THE IMAGES

Application:
It is applied by spray with traditional guns, with airless systems, and with a brush.
Drying can be accelerated in an oven at a maximum temperature of 80-100°C.
To achieve proper drying of the enamel, it is advisable that this does not occur at temperatures below 10°C and with relative humidity not exceeding 70%.

Cycle:
A pretreatment with megasid epoxy primer is recommended.

Technical Data:
Dry Residue (w/w): 64.7 ± 1 %
Viscosity (DIN4/25°C): sec
Pot Life: 10-12 hours at 25°C

Theoretical Yield:
at 30 Microns: 10 sqm ± by spray, for brush and roller approximately 30% is lost
Dilution:
20% by weight with NC 190 epoxy thinner

Catalysis:
For Glossy: 60% by weight with epoxy enamel catalyst
For Semi-Glossy: 30% by weight with epoxy enamel catalyst
For Matte: 30% by weight with epoxy enamel catalyst

Drying:
to the touch: 3-4 hours
throughout: 72 hours

Maximum film resistance is achieved after 7-8 days.