Rholm Primer Primer Spray Glass Fiberglass Carbon fiber Kevlar and Lexan K750

K 750

multiprimer - glass - fiberglass - carbon fiber - Kevlar and Lexan

Recoatable after 30 minutes

DRYING TIMES

Touch dry - 3 minutes

Deep dry - 30 minutes

FEATURES

adhesion primer for painting glass, fiberglass, carbon fiber, Kevlar and Lexan. It does not require high thicknesses, therefore it must be applied in a single coat to veil. Recommended thickness 5 microns

PREPARATION OF THE SUPPORT:

remove all traces of dirt, grease or peeling paint from the surface to be painted. Sand as needed

INSTRUCTIONS FOR USE:

shake the can for about 1 minute. Apply holding the can in vertical position at a distance of about 20 cm. Do not spray with low temperatures and in any case in the presence of humidity. After use, turn the can upside down and spray for a few seconds. Paint removal with acetone and/or nitro thinner

Preparation of the surface:
remove any traces of dirt, grease, or peeling paint from the surface to be painted. Sand as needed.

Instructions for use:
-Shake the can for about 1 minute.
-Apply while holding the can vertically at a distance of about 20 cm.
-Do not spray in cold temperatures and in the presence of humidity.
-After use, turn the can upside down and spray for a few seconds.
-Remove paint with acetone and/or nitro thinner.

Disposal:

Aerosol can: FE40 – Iron collection

Cap and nozzle: PP05 – Plastic collection

Recycle only if perfectly clean and empty.

Otherwise, recycle at appropriate ecological centers.