Polyester base two-component which can be used for total or partial refurbishments of industrial vehicles and cars. MEGASID POLYESTER BASE It has perfect flow, excellent adhesion on various supports and has good anti-rust properties. MEGASID POLYESTER BASECOAT is used by spray as a filler primer or as a filler insulator. It can be applied on polyester primers and fillers, fiberglass, gel coat, primers and epoxy primers.
Polyester filler

During application and drying time, ventilate the room. The use of appropriate PPE during the application phase is recommended. Before operating, carefully read the safety data sheet.

APPLICATION:

After adding the catalyst in the appropriate quantities, it can be applied by spray. It is recommended to apply 2 to 4 coats for a final thickness of 800 microns maximum, with a pressure of 3 to 5 atm and a nozzle of 2.5 - 4 mm. The MEGASID POLYESTER BASECOAT is ready for use, it can be diluted with a specific solvent up to 10% depending on the results you want to obtain.

You can start with a light hand, wait 5/10 minutes depending on the room temperature, then proceed, spray one or two full hands, waiting 5/10 minutes to dry between coats. Or you can, depending on the use, apply a single thick coat.

Do not apply on damp surfaces.

DATA:

Catalysis:

1% workability: 40 minutes Sandability: After 4 Hours

2% workability: 25 minutes Sandability: After 3 hours

3% workability: 20 minutes Sandability: After 2.5 hours

Spray Application:

Nozzle Diameter: 2.5mm to 4.0mm

Air pressure: from 3.0 to 5.0 Bar

Pot Life (product duration after catalysis):

20 40 minutes based on catalysis, dilution and tempering..

Drying:

Dust free: <5 Minutes

Out of print: 20 minutes

Complete Drying <4 Hours

Sandability:

After 3 hours

P360 400 dryo

P600 800 weto

Dry Film Thickness:

400 800 µmm

Theoretical yield:

1 m2 with 600 1100 gr  

Number of hands:

2 4

Disposal:

Jar and Cap: FE40 - Iron Collection

Recycle only if perfectly clean and empty.

Otherwise recycle at appropriate ecological centres.

Hazard Label:

UFI: TDA0-50XW-000E-Q9Y2

H225 Highly flammable liquid and vapour.

H361d Suspected of damaging the unborn child.

H372 Causes damage to organs through prolonged or repeated exposure.

H319 Causes serious eye irritation.

H315 Causes skin irritation.

H335 May cause respiratory irritation.

EUH208 Contains: COBALT BIS(2-ETHYHEXANOATE).

May cause an allergic reaction

P201 Obtain specific instructions before use.

P210 Keep away from heat, hot surfaces, sparks, open flames and other sources of ignition. Not smoking.

P260 Do not breathe dust / fume / gas / mist / vapors / spray.

P280 Wear protective gloves and eye/face protection.

P308+P313 IF exposed or concerned, get medical advice/attention.

P370+P378 In case of fire: use carbon dioxide, foam, chemical powder to extinguish.

Contains: STYRENE

UN 1263 II Class 3

UFI CATALYST CODE: UN10-J0JD-R00X-7GHG